NAVLIGHT INDICATORS


 HOME

 PANELS

 INDICATORS

 CURRENT SENSORS

 ORDER PAGE


 

 

 

 

These LED indicators clearly show which navigation lights you have switched on

.....and those you may have forgotten to switch off.

 

Indicators operate with either 12 VDC or 24 VDC systems and are available in 7 different lens configurations corresponding to specific marine navigation lights. If your electrical switch or circuit breaker panel provides adequate space adjacent to each navigation light switch, the appropriate indicator may be readily installed.

 

 

Now, indicators come in two sizes.
The standard indicators install into 5/16 (0.313) inch diameter holes.
The new miniature indicators install into 11/64 (0.172) inch diameter holes; their lenses are larger than the holes and are interchangeable between miniature indicators.

 

 

Many marine circuit breaker panels incorporate predrilled 11/64 (0.172) inch diameter holes for common 3mm LEDs. In this panel, our miniature indicators are installed in such holes. However, the circular illumination area is about 3 times larger than that of the commom 3mm LED.

 


 

These indicators offer the following:

Clear Indication:

Each lens has red, green and/or white sectors corresponding to the prescribed visibility angles (or points) of a standard marine navigation light. Illumination area is large and distinct with respect to most common indicators.

Very Low Battery Drain:

Indicator illumination is provided by a white LED (light emitting diode). Each indicator draws less than:
2.5 milliamperes (0.0025 amperes) of current at 12 volts DC, or
5.5 milliamperes (0.0055 amperes) of current at 24 volts DC.

Long Life:

These LEDs have inherent long life, up to 100,000 hrs. Lens colors are protected by durable polycarbonate.

Unobtrusive:

Effect on night vision is minimized by limiting LED illumination level and by lenses specifically designed to mute light transmission.

Easy Installation:

The standard indicator presses into a 5/16 inch diameter panel hole. Black nylon body protrudes less than 1 inch through panel. Firmly attached are red (+) and black (-) wire leads, 18 AWG, 9 inches long with 1/2 inch stripped ends.

The miniature indicator presses into an 11/64 inch diameter panel hole. Black nylon body protrudes less than 1/2 inch through panel. Firmly attached are red (+) and yellow (-) wire leads, 26 AWG, 9 inches long with 3/8 inch stripped ends. Snap-on lenses are interchangeable between miniature indicators.


To select and order the indicators best suited for your boat, please use our order page:

 ORDER PAGE